Reading time 2 minutes
|
This article may benefit from a new introduction.
You can help wikiHow by improving the current introduction, or writing a new one to match the format described in the Writer’s Guide. Please remove this notice once this page has been improved. Notice added on: 2015-01-20. |
Want to know how to make a cool Christmas bracelet? This article will teach you how to make one out of Firebrick and Green Pearl beads! Read on!
[Edit]Steps
- Cut off a 80 centimeter (31.5 in) tiger tail. Fold in in half, thread a crimp bead to both wires and pinch the bead, slide a firebrick bead to both wires, then add one firebrick bead to each wire respectively, at last, cross both wires through a green bead and tighten the wire.
- Add one green bead and three firebrick beads to upper wire. Thread the upper wire back through the green bead and tighten, do the same to the below wire, then cross both wires through a green bead and tighten.
- Add one firebrick bead to each wire respectively. Cross both wires through a firebrick bead, thread one firebrick bead to each wire respectively again, cross both wires through a green bead, then repeat 2nd, at last, add one firebrick bead to each wire, cross both wires through a firebrick bead.
- Continue this pattern until the length is suitable for your wrist. Then add one firebrick bead to each wire, thread a firebrick bead to both wires, at last, fix the beads string with a crimp bead as the start end did.
- Connect the bracelet with a jumpring and a lobster clasp.
[Edit]References
- Pandahall Learning Center
